News

Commercial Washer Inlet and Drain Labels: Keep Connection Data Out of Consumption Claims

2026.11.20

Copy the complete connection description

The supplied GD-SXT table lists cold and hot water connections as 3/4 inch and the drain connection as 3 inch across the shown models. Preserve the distinction between the three entries. Do not reduce them to an unlabelled number in a dealer spreadsheet. The stated connection sizes are not measurements of water consumed per cycle or proof that an existing building installation is suitable.

Identify the remaining installation questions

Ask the supplier for the applicable requirements and drawings for the selected configuration. Provide them to the responsible installer for assessment of the premises. This article does not prescribe piping, supply conditions or drainage construction. Record unanswered questions explicitly so a connection-size match is not mistaken for a complete technical approval of the proposed location.

Check how information is used in proposals

A comparison table can show model, connection description, listed size and document source. Keep a separate area for the site reviewer’s conclusions. For example, the same listed inlet dimension on two models does not mean that all other requirements or the installation arrangement are identical. Avoid copying a previous project’s conclusion into a new order solely because these catalogue rows match.

Keep marketing language accurate

When publishing the figures, call them connections and retain the units. Do not attach a water-saving percentage or a per-load consumption estimate that has not been established. If the business later measures operating use, document the measurement boundary and conditions separately. This distinction helps international buyers understand what the specification sheet actually states and what still requires configuration-specific or site-specific confirmation.